Universal Devices ISY-994i Series Guia do Utilizador descarregar pdf (Página 84)

Motion Sensor

Motion Sensors are RF devices, thus require the installation of an INSTEON RF

receiver (such as an INSTEON AccessPoint).

The Motion Sensor cannot be linked using Auto Discover. To link a Motion Sensor to

the ISY, please choose the LINK MANAGEMENT pulldown, then NEW INSTEON

DEVICE. Enter the device address manually (found inside the battery compartment),

then select the “2420M INSTEON Motion Sensor” from the Device Type list.

Since the Motion Sensor is a battery-saving RF device, you must put the device into

linking mode to add it to the ISY (and make any changes to the device, such as

adding/removing from scenes). Please follow the on-screen instructions to put the

Motion Sensor into linking mode when prompted (hold SET button for 5 seconds).

Once added to the ISY, the Motion Sensor will show up as 3 nodes. The primary node

is the motion sensing portion of the device, which updates according to sensed motion

(or lack of motion).

There is also a DUSK/DAWN node that will show ON when the device senses darkness

and show OFF when the device senses light. The Motion Sensor will not update this

node until approximately 3.5 minutes after a state change has persisted.

Finally, a Low Battery node will show as ON when the Motion Sensor senses a low

battery condition and notifies the ISY.

Motion Sensors support several unique options, such as:

 Timeout (minutes) - Defines the period of inactivity before the Motion Sensor will

send an Off. Default = 1 minute. Range = 0.5 - 8.5 minutes in 30 second

increments.

 LED Brightness - Default = 100. Range is 0 - 255.

 Darkness Sensitivity - The higher the value, the darker it needs to be for the unit

to see night. Default = 35. Range = 0 - 255.

RemoteLinc

RemoteLincs are RF devices, thus require the installation of an INSTEON RF receiver

(such as an INSTEON AccessPoint).

RemoteLincs link differently than other INSTEON devices, this require a separate

linking routine. To link a RemoteLinc to your ISY, click the LINK MANAGEMENT

pulldown and choose LINK A REMOTELINC and follow the on-screen instructions.

Since the RemoteLinc is a battery-saving RF device, it must be put into linking mode

whenever adding to the ISY or making changes (such as adding or removing from a

scene). To put the device in linking mode, hold Button 1 down for 10 seconds, or until

1 2 ... 79 80 81 82 83 84 85 86 87 88 89

Sem comentários

Universal Devices ISY-994i Series Guia do Utilizador Página 84