Universal Devices ISY-994i Series Guia do Utilizador descarregar pdf (Página 83)

I/OLinc

Several options are available when configuring an I/OLinc on the ISY. These include:

 Timeout (seconds) - Sets the length of time the relay will close when Momentary

is selected.

 Program Lock - Disables Set Button programming.

 Relay Follows Input - Sets Relay On when Sensor is On and Off when sensor if

Off.

 Send X10 Send On (or Off) - Send X10 when the sensor changes.

 Trigger Off - If the TrigOff bit is set, Close Switch sends an OFF and Open

Switch sends an ON. If the TrigOff bit is clear, Close Switch sends an ON and

Open Switch sends an OFF.

 LED on TX - The LED will flash when the device sends Insteon commands.

 Momentary: A - The relay will close momentary. If it is Linked while On it will

respond to On. If it is Linked while Off it will respond to Off.

 Momentary: Look at Sensor - If the sensor is On the relay will close momentarily

when an On command is received. If the sensor is Off the relay will close

momentarily when an Off command is received.

 Momentary: Both - On and Off both cause the relay to close momentary.

KeypadLinc

KeypadLincs show up as multiple nodes on the ISY (6 button or 8 button, depending on

which model KeypadLinc). When switching between 6 and 8 button modes on the

KeypadLinc, the device must be removed and re-added to the ISY.

Only the KeypadLinc’s primary load button can be controlled directly by the ISY

(through the Admin Console and ISY Programs). To control secondary buttons, create

a Scene containing the button and control the scene.

KeypadLincs support several unique options, such as:

- Manually Exclusive Buttons – groupings of buttons so that one and only one button

in the group can be ON at any one time.

- Toggle Mode – toggle a button to always stay ON or OFF (and only send the

respective command when pressed)

- LED Brightness – adjust the KeypadLinc button LED brightness

Due to variations in KeypadLinc firmware, some configuration options may or may not

be available.

LampLinc

Most LampLincs will not act as controllers – they will not notify the ISY or control other

linked devices if turned on or off locally (via the SET button or using load sensing).

LampLincs labeled v4.2 or higher (firmware v33+) should act as controllers.

1 2 ... 78 79 80 81 82 83 84 85 86 87 88 89

Sem comentários

Universal Devices ISY-994i Series Guia do Utilizador Página 83